OptiPlex 5050 Micro Motherboard User's Manual
Dell OptiPlex 5050 Micro Owner's Manual provides safety instructions and procedures for working inside the computer, including turning the computer off in Windows 10 or Windows 7 and steps to take before and after service. It also describes removing and installing components such as the cover, coin cell battery, 2.5-inch drive assembly, M.2 PCIe SSD, system fan, speaker, memory module, heat sink, processor, and system board.
The manual includes an overview of the M.2 Intel Optane Memory Module 16 GB, USB and HDMI feature information, system setup options, supported operating systems and driver download guidance, troubleshooting with diagnostic LED codes and error messages, technical specifications, and contact information for Dell.
| Regulatory model | D10U |
|---|---|
| Regulatory type | D10U002 |
The procedures require a small flat blade screwdriver, a Phillips #1 screwdriver, and a small plastic scribe.
Loosen the thumbscrew that secures the cover, then slide and lift the cover to remove it; a plastic scribe may be needed to release the cover from the edges.
Save and close all open files, click or tap the Start button, click or tap Power, then click or tap Shut down; if devices do not turn off automatically, press and hold the power button for about 6 seconds.
Hold the battery with the "+" sign facing up, slide it under the securing tabs at the positive side of the connector, and press it into the connector until it locks into place.