Shimpo DT-311J Digital Stroboscope Instruction Manual

The DT-311J is a digital stroboscope designed to assist in mechanical timing adjustments and to emit flashes synchronously with an external signal and an internal signal.


Shimpo DT-311J Digital Stroboscope Instruction Manual - cover page
Brand
Shimpo
Category
Other
Document type
User Manual
Language
English
Pages
12
File format
PDF
File size
434 KB
Published
16 November, 2023
Updated
16 November, 2023
MD5 checksum
910C1B1F4A04A718C654B3D5D8BBAB22

About this manual

This is the English instruction manual for the Shimpo DT-311J and DT-311J-230V(AC) digital stroboscope. It explains that the instrument is designed to assist mechanical timing adjustments and to emit flashes synchronously with an external signal or an internal signal, with flashes delayable from 0 up to 359 degrees at a positive edge of an external signal and the delayed angle shown on the LED display. Revolutions per minute (RPM) can also be displayed.

The manual covers safety instructions, specifications, front and rear panel diagrams, cable connection, mode selection, internal and external signal operation, divide ratio and phase shift settings, flash interval diagrams, the lamp on/off switch, low and high speed alarms, input circuitry, lamp replacement and the initial reset procedure. A 6 m (19') cable with connector, the instruction manual and a warranty card are listed as included accessories.

What's inside

  • General
  • Important Safety Instructions
  • Specifications
  • Diagram (Front Panel and Rear Display/Operation Panel)
  • Cable Connection
  • Mode Selection
  • Internal Signal Operation
  • External Signal Operation
  • Flash Interval
  • Lamp On/Off Switch

Specifications

Flashing range200 – 1,500 rpm
Phase shift0 – 359º
Divided ratio1/1, 1/2, 1/3, 1/4, 2/4 with shift
Display4 digits, 10 mm high, red LED
Input impedance47k ohms
Accuracy+/- 1 digit
Flash tubeXenon lamp, max 10 W at 1,500 rpm, life 100 million flashes
Operating temperature32º - 104º F (0 - 40º C)
Power requirement110 VAC, (230 VAC model) +/-10% at 50/60 Hz
Power consumption20 VA MAX
Dimensions8.43”L x 5.87”W x 6.85”H (214 mm x 149 mm x 174 mm)
Weight4.19 lb (1.9 kg)

Frequently asked questions

What is the flashing range of the DT-311J?

The flashing range is 200 to 1,500 rpm, which is also the internal signal range.

How do I reset the DT-311J to its factory default settings?

Simultaneously press the LAMP ON/OFF button and ZERO, then press the Power switch on. The memory is cleared and the factory default condition resumes.

Which lamp is used when replacing the flash tube?

Only the specified lamp, FLASHTUBE311-J, should be used for replacement.

What happens if the speed goes over 1,550 rpm in external signal mode?

The “over” symbol appears as a high speed indicator, and the stroboscope flash will not function while the alarm symbol is shown.

Download PDF (434 KB)

More Shimpo Manuals


View all Shimpo manuals →