BlueBOLT-CV1 is a power management component that supports IP control and can be connected to an Internet router or modem via an Ethernet cable.
This owner's manual for the Panamax BlueBOLT-CV1 remote power management IP control card explains how to install the card in a BlueBOLT-enabled Power Management Component and how to register it online. Installation is a two-step process: remove any existing RS-232 card, slide the BlueBOLT-CV1 card into the card slot and tighten the knurled thumbscrews, then connect an Ethernet cable between the card and an Internet router or modem.
Registration is done through a web browser at www.mybluebolt.com using the card's unique MAC address and challenge key, which appear on the protective packaging and on the card label. The manual also describes troubleshooting steps (power, card installation, Internet connection), the reset button and the Link and Activity LEDs, plus warranty, service and FCC Class B information. It is printed in English, French and Spanish.
| Warranty period | 3 years from date of purchase |
|---|---|
| Reset button hold time | 10 seconds |
| Link LED state | solid green |
| Activity LED state | blinking intermittently (green) |
| FCC compliance | Class B digital device, part 15 of the FCC Rules |
| Customer service phone | 1-800-472-5555 |
Remove any RS-232 card using the knurled thumbscrews, slide the BlueBOLT-CV1 card into the card slot along the two guiding channels, tighten the thumbscrews, and connect an Ethernet cable to an Internet router or modem.
You need the card's unique MAC address and challenge key, provided on the protective packaging and on the card label, and you register at www.mybluebolt.com.
The Link light should be solid green and the Activity light should be blinking intermittently green when the card is installed properly.
Hold the reset button for ten seconds.