3M™ Super Fast Adhesive is a two part urethane formulated to be used on most plastic substrates as a fast curing adhesive with excellent gap filling capabilities.
This 3M instruction sheet covers 3M Super Fast Adhesive, a two-part urethane formulated for use on most plastic substrates as a fast curing adhesive with gap filling capabilities. It is also listed for repairing or replacing broken or missing mounting tabs, general purpose bonding, and replacing worn or stripped threads. The product is used with a 50 mL EPX applicator, part number 08190.
The document walks through surface preparation (soap and water wash, 80 or 180 grade abrasive, dust removal, 3M Polyolefin Adhesion Promoter PN 05907), cartridge and mixing nozzle preparation, and the general repair process of applying adhesive and holding parts together for 30 to 45 seconds. It also gives typical work, clamp, sand and paint times measured at 70°F, plus precautionary information, application warnings, clean-up and storage notes.
| Work time | 20 seconds |
|---|---|
| Clamp time | 1 minute |
| Sand time | 5 minutes |
| Paint time | 30 minutes |
| Cartridge size / applicator | 50 mL EPX applicator PN 08190 |
| Time values measured at | 70°F ambient air and substrate temperature |
| Cure before service | 1 hour |
They were determined with ambient air and substrate temperature at 70°F and are considered typical values.
Apply adhesive to one part, assemble the parts immediately and hold them together for 30 to 45 seconds.
Allow the repair to cure for 1 hour before putting the repaired part into service.
Leave the mix nozzle in place so it seals the cartridge.