The document is about the user manual of Harman fireplace.
This document is the installation and operation manual (Manuel d'installation et d'utilisation) for the Harman XXV pellet-burning room heater, distributed by Hearth & Home Technologies. It carries safety warnings in French and English, notes that the appliance is listed for use in manufactured homes, and directs readers to contact their Harman dealer or www.harmanstoves.com for a French translation.
The manual explains which fuels may be burned (PFI-certified wood pellets or shelled corn mixed with pellets up to 50%), how to store them, and the problems caused by high ash content, moisture and clinkers. It also lists the appliance's heat output, efficiency, electrical ratings, clearances to combustibles and floor protection requirements, and warns that burning treated seed corn or other fuels voids the warranty and can be dangerous. This manual is written in French.
| Nominal heat output | 10.5 kW |
|---|---|
| Reduced heat output | 1.8 kW |
| Efficiency (nominal / reduced) | 84% / 73% |
| CO concentration at nominal output | < 0.02% |
| Max fuel consumption | 5.7 lb/hr (2.9 kg/h) |
| Electrical rating (240 V) | 240 VAC, 50 Hz, start 2.6 A, run 2.0 A |
| Electrical rating (115 V) | 115 VAC, 60 Hz, start 4.2 A, run 3.6 A |
| Pellet diameter | 6 to 8 mm (1/4" or 5/16") |
| Max pellet length | 38 mm (1.5") |
| Clearance, back wall | 76 mm (3") |
| Clearance, side wall | 305 mm (12") |
| Clearance, corner installation | 159 mm (6.25") |
| Floor protection, front | 450 mm (6") |
| Flue gas temperature | 224 °C |
| Venting system | 3" or 4" diameter type "L" or "PL" |
Only wood pellets, or shelled corn mixed with wood pellets (up to 50% corn). Burning other fuels voids the warranty, and burning treated seed corn is dangerous.
Pellets should be 6 to 8 mm (1/4" or 5/16") in diameter and no longer than 38 mm (1.5"). Longer pellets can cause irregular fuel feed or ignition.
The back wall must be 76 mm (3") from the appliance and side walls 305 mm (12"); in a corner installation the walls must be 159 mm (6.25") away.
Yes, it is listed for manufactured home installation, but not in a sleeping room, and an outside combustion air inlet must be provided.