Installation and operating manual for Harman Magnafire Series Mark I and Mark II coal stoves covering safety, assembly, venting, operation, and maintenance.
This manual covers the Harman Magnafire Series Mark I and Mark II coal stoves. It provides safety notices, assembly and installation instructions, venting guidance, grate controls, operating instructions, preventive maintenance, an optional hot water coil, warranty information, and service parts diagrams. The stove is approved for use in the U.S. and Canada and is for coal only.
The manual lists clearances to combustible surfaces, floor protection requirements, and chimney requirements. It states the stove is not approved for mobile/manufactured homes and warns that all surfaces are hot during operation. It also notes paint curing during the first burns and gives ash and fire operating guidance.
| Fuel | Coal only |
|---|---|
| Flue connector diameter | 6 in |
| Chimney type | Factory built 103HT or masonry |
| Electrical rating | 115VAC, 60 Hz, 1.1 Amps |
| Clearance to sidewall | 33 in |
| Clearance to backwall | 24 in |
| Floor protector thickness | Minimum 3/8 in non-combustible material |
| Floor protector front extension | 16 in |
| Test standards | UL 1482-1996, UL 737-1996, ULC-S627-00 |
The heater is approved for burning coal only.
No. The stove is not approved for use in mobile/manufactured homes.
A blue smoke may rise from painted surfaces as the paint cures. Increase fresh air by opening doors or windows during this break-in period.
The manual lists 24 inches to the rear of the stove and 33 inches to the sides.