Harman Stage 2 Custom Installable Speakers Installation Guide

This guide provides installation instructions for Harman Stage 2 series custom installable speakers, including in-wall and ceiling-mount models.


Harman Stage 2 Custom Installable Speakers Installation Guide - cover page
Brand
Harman
Category
Other Electronics
Document type
Installation Guide
Language
Chinese
Pages
10
File format
PDF
File size
1.4 MB
Published
12 October, 2026
Updated
12 October, 2026
MD5 checksum
9B8A4AC40A7A10257A91F4577F8544CA

About this manual

This document serves as an installation guide for the Harman Stage 2 series of custom installable speakers. It covers both in-wall and ceiling-mounted models, detailing safety warnings, preparation steps, mounting procedures, and wiring instructions.

The guide specifies compatible accessories such as pre-fabricated brackets (WB81, WB61, CB6SA, CB8SA) and square grille kits (SGK6, SGK8). It also includes a table correlating wire gauge to distance for proper electrical connections. This manual is written in Chinese.

What's inside

  • Overview
  • Safety Warnings
  • Installation Preparation
  • Mounting the Speaker
  • Specifications
  • Accessories

Specifications

High Frequency Transducer1 inch (25 mm) aluminum dome
Low Frequency TransducerDual 5.25 inch to 8 inch cone woofer
Recommended Amplifier Power20-120W RMS (varies by model)
Nominal Impedance8 ohm

Frequently asked questions

What wire gauge is recommended for runs under 50 feet?

For distances less than 50 feet (15 meters), use 16 AWG wire.

What is the minimum wall thickness required for installation?

The material thickness must be between ½ inch (13 mm) and 2 inches (51 mm).

Download PDF (1.4 MB)

More Harman Manuals


View all Harman manuals →