This manual introduces the installation method of the Centurion Systems D10 Smart / D10 Turbo Smart / D20 Smart gate operators.
The D10 SMART is a heavy duty sliding gate operator designed for industrial sliding gates weighing up to 1000kg. The D10 Turbo SMART suits lighter gates that need a high number of operations per day and can reach almost double the speed of the standard D10 SMART, but is not suitable for gates weighing more than 250kg. For large, heavy gates and high traffic volumes, the D20 SMART can move gates weighing up to 2000kg. All three use a die-cast aluminium gearbox coupled to a 24V DC motor and switch-mode charger, and run off two 12V / 7.2 - 8Ah batteries that provide power failure protection. A non-contact Hall Effect Sensor provides positional feedback and is resistant to dust, oil, dirt and insect ingress.
This installation manual covers safety information, lightning and theft protection, specifications and physical dimensions, product identification, required tools and equipment, and new site preparation including endstops, guide-rollers, running forces and cabling. It then takes the installer through lubrication, locating and mounting the operator on a foundation plate or retro-fitting to an existing site, cable routing, manual override, height adjustment, rack mounting, reassembly, the origin sensor and marker, fitting the batteries, wiring the control card on its default settings (i5 and Photon infrared beams, external radio receiver, loop detector and G-ULTRA), commissioning, applying the warning decal, general maintenance, installation handover and warranty information.
| D10 SMART gate weight capacity | Up to 1000kg |
|---|---|
| D10 Turbo SMART gate weight limit | Not suitable for gates weighing more than 250kg |
| D20 SMART gate weight capacity | Up to 2000kg |
| Motor and charger | 24V DC motor with switch-mode charger |
| Battery supply | Two 12V / 7.2 - 8Ah batteries |
| Position sensing | Non-contact Hall Effect Sensor |
| Onboard radio receiver capacity | Limited to 1500 NOVA remotes |
The D10 SMART is a heavy duty sliding gate operator designed to open and close industrial sliding gates weighing up to 1000kg.
No. It is not suitable for gates weighing more than 250kg, as the inertia of heavier loads could be detrimental to the gearbox at high speeds.
The system operates off two 12V / 7.2 - 8Ah batteries housed inside the operator, maintained by a switch-mode charger; the batteries provide critical power failure protection.
The electronic controller uses surge protection that returns to earth via the mains power supply earth and/or an earth spike located next to the operator, so the unit must be properly earthed.