Spanish quick guide for installing Centurion Systems D10 SMART, D10 Turbo SMART and D20 SMART sliding gate motors for industrial doors up to 2000 kg.
This quick guide from Centurion Systems (Pty) Ltd is written for installers who are familiar with conventional sliding gate motor installations but not with the special features of the D10 SMART / D10 Turbo SMART / D20 SMART. The D10 SMART is a heavy-duty sliding gate motor for industrial gates up to 1000 kg, while the D10 Turbo SMART suits lighter gates with many daily operations at nearly twice the speed of the standard D10 SMART, though it is not suitable for gates heavier than 250 kg. The D20 SMART moves gates of up to 2000 kg for large, heavy, high-traffic installations.
The guide covers safety instructions, product identification, technical specifications, site preparation, wiring requirements, manual override and installation preparation. The system runs on two 12V 7.2Ah batteries inside the motor kept charged by a switch-mode charger, and a contactless Hall effect sensor provides positional accuracy. The full installation manual is available in the MyCENTSYS Pro mobile app. This manual is written in Spanish.
| Input voltage | 90V - 240V AC +/-10% @ 50Hz |
|---|---|
| Maximum operations per day | 750 |
| Motor power | Battery powered (standard capacity 2x 12V 7.2Ah) |
| Motor push force (start) | 40 kgf (D10 SMART) / 24 kgf (D10 Turbo SMART) / 52 kgf (D20 SMART) |
| Maximum door mass | 1000 kg (D10 SMART) / 250 kg (D10 Turbo SMART) / 2000 kg (D20 SMART) |
| Maximum door length | 50 m (D10 SMART / D10 Turbo SMART) / 25 m (D20 SMART) |
| Door speed (varies with load) | Up to 26 m/min (D10 SMART) / 45 m/min (D10 Turbo SMART) / 18 m/min (D20 SMART) |
| Current consumption (motor at rated load) | 8A (D10 SMART) / 10A (D10 Turbo SMART) / 9A (D20 SMART) |
No, it is not suitable for gates weighing more than 250 kg, because the inertia generated by heavier loads could damage the gearing at such high speeds. For heavier gates the speed must be reduced according to Table 2.
No, the batteries are not included with the D10 SMART / D10 Turbo SMART / D20 SMART.
Make sure the camlock is in the "unlocked" position and pull the release handle to a 90° position; the motor is then placed in a temporary disengaged state.
Yes, it can operate on solar power; consult your local distributor for information.