This is a user guide
This is the user guide for the TomTom GO | VIA car navigation device, published by TomTom International BV. Its contents run from a welcome chapter and Getting started through Getting the most from your device, Keeping your device up-to-date, Troubleshooting and an Addendum of regulatory and copyright notices.
The Getting started section shows how to mount the device: push the mount against the windshield, lock it by twisting the base, place the device on the mount where magnets hold it, and connect the car charger before switching on with the On/Off button on top. It also gives safety advice on where to position the mount, explains how to plan a first route from the Main Menu, and includes special notices for driving in California and Minnesota, FCC and IC information, and connected network details.
| Radio frequency exposure distance | Human proximity to the antenna not less than 20 cm (8 inches) during normal operation |
|---|---|
| Connected GSM/GPRS networks | GSM/GPRS 900/1800/1900 and GSM/GPRS 850/1900 |
| Model names | 4CS03, 4CQ01, 4CT50, 4EN42, 4EN52, 4EV42, 4EV52 |
| FCC ID | S4L4CS03, S4L4CQ01, S4L4CT50, S4L44EV42, S4L44EV52 |
| Battery life | Stated battery life is a maximum possible battery life, achieved only under specific atmospheric conditions |
Push the mount against the windshield and lock it by twisting the base. Then place the device onto the mount, where the magnets hold it securely in place.
Tap the screen to bring up the Main Menu, tap Navigate to..., then tap Address and start typing the name of the town you want to go to.
No. Drivers in California should not use a suction mount on their windshield, side or rear windows; TomTom recommends the supplied Adhesive Mounting Disk or its Alternative Mounting Kit.