This document is an owner's manual for h200 pool heater, including product features, installation and maintenance
The manual covers Hayward H150FD, H200FD, H250FD, H300FD, H350FD and H400FD pool and spa/hot tub heaters. It provides service and installation instructions, safety warnings, electrical bonding and suction outlet requirements, vent piping guidance, and high-altitude installation notes.
Maintenance content includes periodic inspection, winterization, draining the heat exchanger and spring start-up. The document repeatedly states that only Hayward genuine replacement parts should be used.
| Models covered | H150FD, H200FD, H250FD, H300FD, H350FD and H400FD |
|---|---|
| Heat exchanger material | Copper and nickel (Cupronickel) |
| Indoor installation above 2,000 ft | Special vent pressure switch required in addition to the blower air inlet plate |
| Installation above 7,700 ft | High-altitude kit required |
The heat exchanger is made from copper and nickel (Cupronickel) materials.
A special vent pressure switch must be installed in addition to the blower air inlet plate.
The manual says to use only Hayward genuine replacement parts.
Allow the motor to cool for at least 20 minutes before maintenance to minimize the risk of burns.