This manual introduces basic information on the installation, use and maintenance of the HeatPro pool heat pump
The Hayward HeatPro pool heat pump is described in this owner's manual as a self-contained unit designed for pool heating. The manual covers safety instructions, installation location, water piping, electrical connections and bonding, use with an external controller, operation, display codes, troubleshooting, maintenance, and winterizing.
The text also notes features including an electronic board with service analyzer, a titanium heat exchanger tube warranted for 10 years against corrosion, and a UV-resistant plastic cabinet. It provides clearance and base requirements and instructions for initial startup and winterizing.
| Heat exchanger | Titanium heat exchanger tube warranted for 10 years against corrosion |
|---|---|
| Cabinet | UV-resistant plastic cabinet |
| Minimum top clearance | 72 inches above the unit |
| Side clearance | At least 24 inches from a wall or other obstruction |
It is designed for outdoor installation and should not be installed in a fully enclosed area such as a shed or garage. Clearances are required for air intake and service access.
Power the unit off first; the manual states the unit must always be powered off before the access panel is opened.
Turn the breaker off, drain all water, disconnect the IN and OUT water connections, and tilt or blow out the unit until all water is out.
Yes. The manual says it is designed to operate continuously and may need to run for up to 24 hours per day.