This document is the user manual for DC Interface Box
This manual provides instructions for using the DC Interface Box with Newport Corporation's MM2000 and ESP6000 motion controllers. It covers installation, connector pin assignments, maintenance, and troubleshooting. The DC Interface Box supports small DC motors and includes relay control for motor OFF functionality. It features LED indicators for power status and is designed for both direct motor control and pass-through configurations with external drivers.
The manual includes detailed wiring diagrams, jumper settings, and technical specifications for the DC Module. It also outlines safety considerations and warranty information, including repair procedures and service contacts for Newport Corporation.
| Power Voltage Indicators | LOW (Red), NORMAL (Green), HIGH (Red) LEDs |
|---|---|
| Relay Control Modes | Three modes for MM2000: all relays controlled by one I/O line, each relay controlled by a different I/O line, or relays always closed |
It uses three LEDs: LOW (Red) for low voltage, NORMAL (Green) for normal voltage, and HIGH (Red) for high voltage.
The DCIB DC Module is capable of driving small DC motors up to 400 mA.
The NORMAL LED illuminates when the external power voltage is between 12 and 19 volts.
If voltage is over 19 volts, the relay will open and the HIGH (Red) LED will illuminate.