This document is about ECU-02 Automatic Engine Control Unit Operators Manual, which mainly introduces the front panel layout, operation control, programming instructions, protection and alarms, and installation instructions.
This manual provides instructions for operating and programming the ECU-02 Automatic Engine Control Unit. It details auto, manual, and off modes of operation, including start sequences, alarms, and shutdown procedures. Programming is done via front and rear panel buttons without requiring a PC. Installation guidelines, electrical connections, and fault-finding steps are also included.
The unit monitors engine and generator performance, displays parameters like voltage, amperage, and hour meter, and offers overload protection. Remote start is supported via standard two-wire signals, and the unit can be configured for pre-heat, warm-up, and cool-down delays.
The ECU-02 Generator Control module is used to start and stop a generator-set automatically.
If voltages drop under 6Vdc during cranking, the ECU may become ineffective and require a reset.
You must push the PROM button on the rear panel for 4 seconds to start programming.