FANUC R-30iB Plus Start Up Guide (CIP Safety)

This document describes the hardware and software requirements for FANUC R-30iB Plus, as well as the steps for installing the safety controller, READY pendant, and connecting the robot and IPC.


FANUC R-30iB Plus Start Up Guide (CIP Safety) - cover page
Brand
FANUC
Category
Industrial Robot
Document type
User Manual
Language
English
Pages
48
File format
PDF
File size
1 MB
Published
17 October, 2023
Updated
17 October, 2023
MD5 checksum
D5065DD2B898C2539A376F7A3974AF25

About this manual

This guide walks you through setting up the FANUC R-30iB Plus safety controller with CIP Safety for READY Robotics systems. It covers hardware and software requirements, connecting components, powering on, configuring safety settings, and programming the controller. The guide also includes steps for configuring the robot for Forge/OS and controlling it with the READY pendant.

The document assumes you have a READY pendant, an industrial PC (IPC), and compatible safety hardware. It provides detailed instructions for installing safety hardware, connecting devices, and verifying software versions. It also includes troubleshooting steps and resources for further support.

What's inside

  • Overview
  • Hardware Requirements
  • Software Requirements
  • Installing the Safety Controller
  • Connecting the READY pendant
  • Connecting the Robot and IPC
  • Powering On
  • Setting Up FANUC CIP Safety
  • Programming the Safety Controller
  • Signing In to Forge/OS

Frequently asked questions

What hardware is required to set up the FANUC R-30iB Plus safety controller?

You need a READY pendant, an industrial PC (IPC), a FANUC R-30iB or R-30iB Plus Robot Controller (A Cabinet), a 24V/2.5A power supply, and a third-party safety PLC with CIP Safety.

What software version is required for the FANUC R-30iB Plus?

The required firmware is R-30iB Plus Firmware: V9.10P/33 (02/2021) or equivalent.

How do I verify the software version on the FANUC controller?

Press the STATUS button on the teach pendant, then press [TYPE] (F1), then Version ID (2). Look for Software Edition No. and note the version number.

How do I reset the robot after configuring the safety controller?

On the READY pendant, tap the Device Status button to expand the Device Status Panel, then tap the RESET button on the list next to the robot. This clears the faults on the robot and gives you control of it.

Download PDF (1 MB)

More FANUC Manuals


View all FANUC manuals →