This is a Philips MP3-CD audio system with model number FWM37/ 21. The rated power is 35W, and the working voltage is 110–127 / 220–240V~, 50–60 Hz.
This manual explains how to install and operate the Philips FWM37 Mini Hi‑Fi System, including power connection, voltage selector settings, speaker and antenna wiring, and remote‑control battery installation. It also covers basic functions such as play, pause, mode selection, and clock/timer features.
Additional sections describe technical specifications, recommended cleaning and maintenance procedures, and a troubleshooting guide for common issues like poor reception, tape problems, or power failures. This manual is written in Spanish.
| Power consumption (operating) | 35 W |
|---|---|
| Standby power consumption | ≤ 15 W |
| Amplifier output power | 2 × 60 W RMS |
| Frequency response (amplifier) | 50 – 15000 Hz |
| Signal‑to‑noise ratio | ≥ 67 dBA (IEC) |
| Input sensitivity (AUX/CDR) | 500 mV / 1 V |
| Speaker impedance (minimum) | ≥ 6 Ω |
| CD/MP3‑CD bit rate | 32‑256 kbps (recommended 128 kbps) |
| FM band range | 87.5 – 108 MHz |
| MW band range | 531 – 1602 kHz |
| Dimensions (with speakers) | 248 × 310 × 195 mm |
| Weight (with speakers) | 3.3 kg |
Set the voltage selector on the back of the unit to 110 V‑127 V if your local supply is 110‑127 V; otherwise leave it at 220 V‑240 V.
Open the battery compartment, insert two R06 or AA batteries with the correct polarity (+/‑) as shown on the compartment.
Use Philips‑branded CD laser head cleaning fluid or another approved cleaning solution, following the product’s instructions.
The standby power consumption is 15 W or less.