Texas Instruments Professional Computer Error 2: Address Mark

Texas Instruments Professional Computer · taken from the manufacturer’s manual, pages cited

Error code2

The controller did not receive a SEEK COMPLETE signal after seek or failed to detect the target address mark on disk. The manual lists no action for this code.

Model
Texas Instruments Professional Computer
Display shows
Address Mark (2)
Type
Error code
Source
Manual p. 97

What 2 means

Address Mark p. 97

Common causes

  • The controller did not get a SEEK COMPLETE signal from the drive after seek operation. p. 97
  • The controller did not detect the target address mark (AM) on the disk. p. 97

If 2 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Texas Instruments service.

Open the manual at page 97 All Professional Computer error codes Manual details & download

This page summarises what the manufacturer’s manual says about 2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Texas Instruments. Found a mistake? Report an error.