Stanford Research Systems DS360 Error DSP 2

DS360 Ultra Low Distortion Function Generator · taken from the manufacturer’s manual, pages cited

Error codeDSP 2

DSP address bus and memory cell error detected. The manual lists no action for this code.

Model
Stanford Research Systems DS360
Display shows
DSP 2
Type
Error code
Source
Manual p. 57

What DSP 2 means

DSP address bus and memory cell error. The message is followed by a six digit (hex) code, made up of three words. Bits 0-15 are DSP address lines 0-15. Bits 16-18 are set if there is an error on the X, Y or P memory spaces. Bits 19-21 are set if there is an error in the low (D0-7), middle (D8-15) or high (D16-23) bytes of the memory space. p. 57

Common causes

  • DSP address bus and memory cell error. The message is followed by a six digit (hex) code, made up of three words. Bits 0-15 are DSP address lines 0-15. Bits 16-18 are set if there is an error on the X, Y or P memory spaces. Bits 19-21 are set if there is an error in the low (D0-7), middle (D8-15) or high (D16-23) bytes of the memory space. p. 57

Safety warnings — read before you start

  • DANGERDANGER. Dangerous voltages, capable of causing injury or death, are present in this instrument. Use extreme caution whenever the instrument is cover is removed. Do not remove the cover while the unit is plugged in to a live outlet. p. 3

If DSP 2 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Stanford Research Systems service.

Open the manual at page 57 All DS360 error codes Manual details & download

This page summarises what the manufacturer’s manual says about DSP 2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Stanford Research Systems. Found a mistake? Report an error.