Stanford Research Systems DS360 Error DSP 1

DS360 Ultra Low Distortion Function Generator · taken from the manufacturer’s manual, pages cited

Error codeDSP 1

DSP data bus error occurred, with six-digit hex code indicating which of the 24 data lines are faulty The manual lists no action for this code.

Model
Stanford Research Systems DS360
Display shows
DSP 1
Type
Error code
Source
Manual p. 57

What DSP 1 means

DSP data bus error. The message is followed by a six digit (hex) code, corresponding to each data line (of 24) that is in error. p. 57

Common causes

  • DSP data bus error. The message is followed by a six digit (hex) code, corresponding to each data line (of 24) that is in error. p. 57

Safety warnings — read before you start

  • DANGERDANGER. Dangerous voltages, capable of causing injury or death, are present in this instrument. Use extreme caution whenever the instrument is cover is removed. p. 3
  • WARNINGWARNING. !WARNING Verify that the LINE VOLTAGE SELECTOR card is set so the correct AC input voltage value is visible. p. 32
  • CAUTIONCAUTION. Caution This instrument may be damaged if operated with the LINE VOLTAGE SELECTOR set to the wrong AC line voltage, or if the wrong fuse is installed. p. 32

If DSP 1 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Stanford Research Systems service.

Open the manual at page 57 All DS360 error codes Manual details & download

This page summarises what the manufacturer’s manual says about DSP 1; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Stanford Research Systems. Found a mistake? Report an error.