Siemens MICRO MASTER and MIDI MASTER Error F201: P006 = 1 while P201 = 2

Inverter · taken from the manufacturer’s manual, pages cited

Fault codeF201

P006 = 1 while P201 = 2 indicates a conflict between parameter settings for fixed frequency and motor potentiometer control modes. The manual's first action is: “Change parameter P006 and/or P201.”

Model
Siemens MICRO MASTER and MIDI MASTER
Display shows
P006 = 1 while P201 = 2 (F201)
Type
Fault code
Source
Manual p. 42

What F201 means

P006 = 1 while P201 = 2 p. 42

What to do

  1. Change parameter P006 and/or P201. p. 42

Before you service the product, read the safety instructions in the manual p. 4.

If F201 is still not resolved

  • Only qualified personnel may connect, start the system up and repair faults. p. 3
    “Only qualified personnel may connect, start the system up and repair faults.”
  • These personnel must be thoroughly acquainted with all the warnings and operating procedures contained in this manual. p. 3
    “These personnel must be thoroughly acquainted with all the warnings and operating procedures contained in this manual.”
Open the manual at page 42 All MICRO MASTER and MIDI MASTER error codes Manual details & download

This page summarises what the manufacturer’s manual says about F201; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.