Siemens MICRO MASTER and MIDI MASTER Error F010: Initialisation fault ³

Inverter · taken from the manufacturer’s manual, pages cited

Fault codeF010

Initialisation fault occurs when the parameter set is corrupted or incomplete, requiring resetting P009 to '0000' before power down. The manual's first action is: “Check the entire parameter set. Set P009 to '0000' before power down.”

Model
Siemens MICRO MASTER and MIDI MASTER
Display shows
Initialisation fault ³ (F010)
Type
Fault code
Source
Manual p. 42

What F010 means

Initialisation fault ³ p. 42

What to do

  1. Check the entire parameter set. Set P009 to '0000' before power down. p. 42

Before you service the product, read the safety instructions in the manual p. 4.

If F010 is still not resolved

  • Only qualified personnel may connect, start the system up and repair faults. p. 3
    “Only qualified personnel may connect, start the system up and repair faults.”
  • These personnel must be thoroughly acquainted with all the warnings and operating procedures contained in this manual. p. 3
    “These personnel must be thoroughly acquainted with all the warnings and operating procedures contained in this manual.”
Open the manual at page 42 All MICRO MASTER and MIDI MASTER error codes Manual details & download

This page summarises what the manufacturer’s manual says about F010; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Siemens. Found a mistake? Report an error.