UCS CONFIGURATION MODE ERROR occurs due to protocol mismatch between MULTI CONTROLLER and PLC or RS232C cable noise interference. The manual's first action is: “Select a proper communication protocol.”
- Model
- Sanyo Machine Works SDNR
- Display shows
- UCS CONFIGURATION MODE ERROR (C2)
- Type
- Error code
- Source
- Manual p. 107
What C2 means
UCS CONFIGURATION MODE ERROR p. 140
Common causes
- The MULTI CONTROLLER and PLC protocol are mismatches. p. 140
- The aberration of the RS232C cable by noise etc.. p. 140
What to do
- Select a proper communication protocol. p. 140
- Inform us about the environment (power noise or another noise source, etc.) around the NUTRUNNER system. p. 140
Before you service the product, read the safety instructions in the manual p. 65.
If C2 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Sanyo Machine Works service.
This page summarises what the manufacturer’s manual says about C2; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Sanyo Machine Works. Found a mistake? Report an error.