MC EMERGENCY STOP occurs when the EMERGENCY STOP input signal (normally open) is activated or (normally closed) is deactivated, requiring release of the signal and reset. The manual's first action is: “Release the EMERGENCY STOP input signal of I/O interface of the MULTI CONTROLLER and reset the problem by activating the RESET input signal.”
- Model
- Sanyo Machine Works SDNR
- Display shows
- MC EMERGENCY STOP (BF)
- Type
- Error code
- Source
- Manual p. 134
What BF means
MC EMERGENCY STOP p. 134
Common causes
- The MC EMERGENCY STOP input signal (to the MULTI CONTROLLER) set up as normally open, is activated (ON). Or, when the EMERGENCY STOP input signal set up as normally close, is deactivated (OFF). p. 134
What to do
- Release the EMERGENCY STOP input signal of I/O interface of the MULTI CONTROLLER and reset the problem by activating the RESET input signal. p. 134
Before you service the product, read the safety instructions in the manual p. 65.
If BF is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Sanyo Machine Works service.
This page summarises what the manufacturer’s manual says about BF; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Sanyo Machine Works. Found a mistake? Report an error.