Sanyo Machine Works SDNR Error 50: SLOPE CALCULATION ERROR (0)

AC Servo Nutrunner · taken from the manufacturer’s manual, pages cited

Error code50

SLOPE CALCULATION ERROR (0) occurs when dividing by zero during SLOPE calculation. The manual lists no action for this code.

Model
Sanyo Machine Works SDNR
Display shows
SLOPE CALCULATION ERROR (0) (50)
Type
Error code
Source
Manual p. 103

What 50 means

SLOPE CALCULATION ERROR (0) p. 103

Common causes

  • The error which occurs when the calculation of SLOPE is calculated. It occurs when a denominator is 0 divide. p. 103

If 50 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Sanyo Machine Works service.

Open the manual at page 103 All SDNR error codes Manual details & download

This page summarises what the manufacturer’s manual says about 50; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Sanyo Machine Works. Found a mistake? Report an error.