Rockwell Automation PowerFlex 400 FRN 4.xx Error F6: Motor Stalled(1)

PowerFlex 400 FRN 4.xx · taken from the manufacturer’s manual, pages cited

Fault codeF6

Motor Stalled(1) occurs when the load is too heavy and requires increasing the acceleration time to reduce output current. The manual lists no action for this code.

Model
Rockwell Automation PowerFlex 400 FRN 4.xx
Display shows
Motor Stalled(1) (F6)
Type
Fault code
Source
Manual p. 25

What F6 means

Motor Stalled(1) p. 25

Common causes

  • Increase Accel Time (r) to reduce load so drive output current does not exceed the current set by parameter A099 [Current Limit]. p. 25

If F6 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

Open the manual at page 25 All PowerFlex 400 FRN 4.xx error codes Manual details & download

This page summarises what the manufacturer’s manual says about F6; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.