Rockwell Automation MicroLogix 1400 Error FBH: Target node cannot respond because another node is program owner (has sole access to all files).

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error codeFBH

Target node cannot respond because another node is program owner (has sole access to all files). The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
FBH
Type
Error code
Source
Manual p. 311

What FBH means

Target node cannot respond because another node is program owner (has sole access to all files). p. 311

Common causes

  • Target node cannot respond because another node is program owner (has sole access to all files). p. 311

If FBH is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about FBH; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.