Rockwell Automation MicroLogix 1400 Error 17: ERR_PACKET_ALLOC

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code17

ERR_PACKET_ALLOC: Firmware use only, Invalid IP address in the parameter of the service. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
ERR_PACKET_ALLOC (17)
Type
Error code
Source
Manual p. 329

What 17 means

ERR_PACKET_ALLOC p. 329

Common causes

  • Firmware use only p. 329
  • Invalid IP address in the parameter of the service. p. 329

If 17 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 17; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.