Rockwell Automation MicroLogix 1400 Error 60H: Target node cannot respond because the file is protected

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code60H

Target node cannot respond because the file is protected. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Target node cannot respond because the file is protected (60H)
Type
Error code
Source
Manual p. 310

What 60H means

Target node cannot respond because the file is protected p. 310

Common causes

  • Target node cannot respond because the file is protected. p. 310

If 60H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 60H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.