Rockwell Automation MicroLogix 1400 Error 50H: Target node is out of memory

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code50H

Target node is out of memory. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
Target node is out of memory (50H)
Type
Error code
Source
Manual p. 310

What 50H means

Target node is out of memory p. 310

Common causes

  • Target node is out of memory. p. 310

If 50H is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 50H; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.