Rockwell Automation MicroLogix 1400 Error 08: FORCE_BUFFER_RETURN

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code08

Code 08 means a MS5 buffer was returned while DeleteSocket or DeleteAllSockets services were being executed, or during inactivity timer expiration. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
FORCE_BUFFER_RETURN (08)
Type
Error code
Source
Manual p. 354

What 08 means

FORCE_BUFFER_RETURN p. 354

Common causes

  • MS5 buffer has been returned while DeleteSocket or DeleteAllSockets services are executed, or while the inactivity timer is expired. p. 354

If 08 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 08; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.