Rockwell Automation MicroLogix 1400 Error 05: CONNECTION_BROKEN

MicroLogix 1400 Programmable Controller · taken from the manufacturer’s manual, pages cited

Error code05

Code 05 means a TCP connection was broken during a Read or Write operation. The manual lists no action for this code.

Model
Rockwell Automation MicroLogix 1400
Display shows
CONNECTION_BROKEN (05)
Type
Error code
Source
Manual p. 354

What 05 means

CONNECTION_BROKEN p. 354

Common causes

  • TCP connection has been broken when Read or Write operation. p. 354

If 05 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Rockwell Automation service.

This page summarises what the manufacturer’s manual says about 05; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Rockwell Automation. Found a mistake? Report an error.