Error codeMONT
Operating angle out of range triggers auto-calibration failure during step 4. The manual's first action is: “MONT is shown during step 4 and an auto-calibration process is finished without completion.”
- Model
- Power-Genex SS5L / SS5R Series
- Display shows
- Operating angle out of range (MONT)
- Type
- Error code
- Source
- Manual p. 33
What MONT means
Operating angle out of range p. 33
Common causes
- Operating angle out of range p. 33
What to do
- MONT is shown during step 4 and an auto-calibration process is finished without completion. p. 33
If MONT is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact Power-Genex service.
This page summarises what the manufacturer’s manual says about MONT; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Power-Genex. Found a mistake? Report an error.