Power-Genex SS5L / SS5R Series Error FBFT: Feedback error (0 - 1%)

Smart valve positioner · taken from the manufacturer’s manual, pages cited

Error codeFBFT

Feedback error (0 - 1%) shows auto-calibration failed without completing step 4. The manual's first action is: “PM00 is shown at step 4 and an auto-calibration is finished without completion.”

Model
Power-Genex SS5L / SS5R Series
Display shows
Feedback error (0 - 1%) (FBFT)
Type
Error code
Source
Manual p. 33

What FBFT means

Feedback error (0 - 1%) p. 33

Common causes

  • Feedback error (0 - 1%) p. 33

What to do

  1. PM00 is shown at step 4 and an auto-calibration is finished without completion. p. 33

If FBFT is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Power-Genex service.

Open the manual at page 33 All SS5L / SS5R Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about FBFT; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Power-Genex. Found a mistake? Report an error.