Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A connector or DC controller PCB is faulty, causing an error that may resolve with a simple power cycle. The manual's first action is: “Turn off and then on the power switch. Is the problem corrected?”
A connector or ADF PCB is malfunctioning, leading to a problem that may be resolved by power cycling the unit. The manual's first action is: “Turn off and then on the power switch. Is the problem corrected?”
The DC controller PCB is faulty, causing an error indicating a system-wide failure. The manual's first action is: “End.”
The DC controller PCB is faulty, resulting in a general malfunction that cannot be resolved by simple reset. The manual's first action is: “End.”
The accessory counter (CNT2) or DC controller PCB has an open circuit, preventing proper counting of accessories. The manual's first action is: “Check the wiring from the DC controller PCB to the counter; if normal, r…
A connector, power supply PCB, or main motor (M1) is faulty, causing a failure in the system's basic operation. The manual's first action is: “Connect the connectors.”
The fixing heater (H1) or triac or DC controller PCB is malfunctioning, preventing the heater from operating properly. The manual's first action is: “Execute service mode '412' (error clear) to clear E004. Turn on the…
Thermistors (TH1, TH2), fixing heater (H1), or thermal switch (TSW1) have poor contact or are open-circuited, causing a heating system fault. The manual lists no action for this code.
Thermistors (TH1, TH2), fixing heater (H1), or thermal switch (TSW1) have poor contact or are open-circuited, causing a heating system fault. The manual lists no action for this code.
Thermistors (TH1, TH2) or the DC controller PCB or triac are faulty, causing an error that indicates a temperature sensing issue. The manual's first action is: “Execute service mode '412' (error clear) to clear E001. …
The fixing heater fails to turn on due to a malfunction in the main or sub thermistor or the fixing heater itself. The manual's first action is: “Execute service mode '412' (error clear) to clear E000. Open the front …
All 37 error codes of the Canon NP7161/NP7160 copier with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The rectifier has failed. The manual's first action is: “1. Toggle the ON/STBY switch into the STBY position and then back into the ON position. 2. If the problem is not corrected, replace the rectifier.”
Rectifier Fail alarm indicates a failure in the rectifier component. The manual's first action is: “1. Verify that there is no obstruction of the fan inlet. 2. Toggle the ON/STBY switch into the STBY position and then…
All 2 error codes of the General Electric 4812/24 rectifier with their meaning, causes and what to do, taken from the manufacturer's manual with page references.