Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
System RAM error - System RAM Failed at offset. The manual's first action is: “1. DIMM 2. System board”
Monitor type error - Monitor type does not match the one specified in CMOS. The manual's first action is: “Load Setup Defaults in BIOS Setup Utility.”
The keyboard controller has failed. The manual's first action is: “System board.”
The system detected an error with the keyboard. The manual's first action is: “Run interactive tests of the keyboard and the auxiliary input device.”
The system detected a stuck key on the keyboard. The manual's first action is: “1. Check the keyboard if it is pressed. 2. Replace the keyboard.”
The hard disk is not working. The manual's first action is: “1. Reset the hard-disk drive. 2. Load Setup Defaults in BIOS Setup Utility. 3. Hard-disk drive. 4. System board.”
All 9 error codes of the LG 130 Series LG 130 Series with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Parameter is under password protection The manual's first action is: “Parameter is under password protection”
Parameter is not changeable during the running The manual's first action is: “Parameter is not changeable during the running”
The system indicates that a parameter cannot be changed. The manual's first action is: “Parameter is not changeable”
Message frame error: including message length error and check error The manual's first action is: “Message frame error: including message length error and check error”
Slave is busy, please try again later; mainly used for storing data into non-volatile storage The manual's first action is: “Slave is busy, please try again later; mainly used for storing data into non-volatile storage”
Command is valid and being processed, mainly used for storing data to non-volatile storage The manual's first action is: “Command is valid and being processed, mainly used for storing data to non-volatile storage”
Slave operation failed due to invalid data within valid range The manual's first action is: “Slave operation failed, including errors caused by invalid data although there are in the range”
Data error indicating data is outside acceptable upper or lower limits The manual's first action is: “Data error, i.e. data are out of upper limit or lower limit”