Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The system detected excessive segment motion in low/high range. The manual's first action is: “(1)Reduce the speed in the step where the alarm occurred. (2)Change the move instruction to joint interpolation (MOVJ). * …
The code 4409 indicates two steps are set to the same position when three taught points are required for an user coordinate system. The manual's first action is: “(1)Check the following settings. - Check the settings …
The controller detected two circular interpolation steps set to the same position. The manual's first action is: “(1)Check the following settings. - Check the settings for teaching position of circular interpolation s…
Instruction prereading processing has not been completed normally. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then c…
Intermediate code is not defined. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa representativ…
An error occurred in instruction prefetch queue operation. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact y…
The system detected an undefined job start condition. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Y…
An undefined interrupt command was received. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa re…
An error occurred in RMS960 system call. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa repres…
An error occurred when system number (MSS) was obtained. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact you…
The specified A_BANK number does not exist. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa rep…
A_BANK conversion could not be performed. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa repre…
The system detected a defective taught point in an endless motion mode. The manual's first action is: “-Checking the command soft (JOB) -MRESET instruction to corresponding axis”
The TWIN DRIVE OVER DEVIATION alarm indicates an axis deviation exceeding limits. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, replace controller. Save the CMOS.BIN before replace c…
The drive belt has snapped or failed. The manual's first action is: “Check that the driving belt is not broken.”