Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Alarm, Day/Night indicates a day or night mode alarm condition has been triggered. The manual lists no action for this code.
Alarm, Entry/Exit indicates entry or exit zones have triggered an alarm. The manual lists no action for this code.
Alarm, Interior indicates an interior zone has triggered an alarm. The manual lists no action for this code.
Alarm, Perimeter indicates a perimeter zone has triggered an alarm. The manual lists no action for this code.
Alarm, 24-hour Audible indicates an audible alarm active for 24 hours. The manual lists no action for this code.
Alarm, 24-hour Silent indicates an alarm that is silent for 24 hours. The manual lists no action for this code.
Duress indicates the system has detected a duress situation. The manual lists no action for this code.
Fire Alarm indicates the system has detected a fire condition. The manual lists no action for this code.
Trouble Restore Report Code is sent when a trouble in a zone is resolved. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and required for residential fire alarm installations.”
Alarm Restore Report Code is sent when an alarm zone returns to its non-faulted state. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and required for residential fire alarm …
Cancel Report Code is sent upon disarming after an alarm condition was reported. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and required for residential fire alarm instal…
RF Trans. Low Batt. Report Code is sent when a wireless transmitter has a low-battery condition. The manual's first action is: “UL installations: must be enabled if wireless devices are used.”
Arm Away/Stay Report Code allows independent programming of Away and Stay reports for each partition, including lobby. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and requ…
Open Report Code is sent upon disarming of the system in selected partitions. The manual's first action is: “UL: Required for UL commercial burglar alarm installations.”
Test Report Code is sent periodically to verify communicator and phone line functionality, with frequency set via scheduling or key commands. The manual's first action is: “installer code + [#] + 0 + 0 = test report s…