Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Error 241 indicates a failure in the power-on test of this instrument. The manual's first action is: “Contact an Agilent Technology sales office or the company from which you bought the instrument.”
The instrument detected numeric data that is not allowed in its current context. The manual lists no action for this code.
A numeric value data error has occurred in the instrument. The manual lists no action for this code.
Error 52 indicates no valid memory trace data is available. The manual lists no action for this code.
The connector measurement function of the SRL measurement is performed with fewer than 101 points. The manual's first action is: “Use at least 101 points.”
The multiport test set calibration is being performed while test set control is not enabled. The manual lists no action for this code.
The command lacks required parameters or has incorrect input. The manual's first action is: “Enter command parameters correctly.”
Log sweep requires 2 octave minimum span The manual's first action is: “Set the stop frequency to more than four times as many as the start frequency. And then select logarithmic sweep.”
The suffix entered is not compliant with IEEE488.2 or 4294A syntax rules. The manual lists no action for this code.
The instrument failed to configure its Electronic Calibration (ECal) module. The manual lists no action for this code.
An expression error occurs when syntactic analysis of data fails to match Error Numbers -171 through -179. The manual lists no action for this code.
An expression-data element has been received at a position where this instrument does not accept one. The manual lists no action for this code.
The exponent value has exceeded the maximum allowed limit of 32,000. The manual lists no action for this code.
An execution error has occurred that the instrument cannot specify a message for. The manual's first action is: “This code shows that an error associated with execution defined in 11.5.1.1.5, IEEE488.2 has occurred. T…
The Ecal module is not connected correctly to the instrument. The manual lists no action for this code.