Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The density value entered is invalid and must be between 0 and 20. The manual's first action is: “Density must be greater than 0 and less than 20.”
One of the room’s dimensions (width, height, or length) is too small or negative. The manual's first action is: “Fix the error then try again.”
The detector's position in the room allows it to pass through a non-radioactive wall, which is not permitted. The manual's first action is: “Change the source-detector location parameters appropriately to fix this err…
One of the tube’s dimensions (width, height, or length) is too small or negative. The manual's first action is: “Fix the error then try again.”
The wall thickness of the rectangular tube has been set too high, as doubling it exceeds either its width or height. The manual's first action is: “Change the wall thickness to fix the error. Then try again.”
The length of the source within the rectangular tube template exceeds its defined limits. The manual's first action is: “Fix the error, then try again.”
The source is positioned outside the boundaries of the rectangular tube template. The manual's first action is: “Fix the error, then try again.”
One or more dimensions of the H-beam are too small or negative, or a Weight value is missing in Weighted Average mode. The manual's first action is: “Fix the error then try again.”
The side wall thickness of the H-beam exceeds its outside width. The manual's first action is: “Change the side wall thickness to fix the error. Then try again.”
The cross-bar thickness of the H-beam exceeds its outside height. The manual's first action is: “Change the cross-bar thickness to fix the error. Then try again.”
The source is positioned outside the boundaries of the L-beam template. The manual's first action is: “Fix the error, then try again.”
The value assigned to the orientation parameter in the L-beam template is invalid. The manual's first action is: “Make sure that the proper value is used to define the orientation parameter, then try again.”
The orientation parameter for the L-beam template is missing in its definition. The manual's first action is: “Insert the orientation parameter in the 'L-beam' template description to fix the error., then try again.”
One or more dimensions of the U-channel are too small or negative. The manual's first action is: “Fix the error, then try again.”
The side wall thickness of the U-channel exceeds the channel’s outside width. The manual's first action is: “Change the side wall thickness to fix the error, then try again.”