Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
EEPROM alarm occurs after power-on when servo unit fails to read EEPROM data, indicating EEPROM chip or circuit panel fault. The manual's first action is: “Restore the motor default parameter.”
DC bus voltage is excessive without braking due to braking circuit fault or open circuit on braking resistor or unconnected resistor. The manual's first action is: “Change the servo drive unit.”
No braking feedback corresponds to braking enable signal because the braking circuit is faulty or braking resistance is excessive. The manual's first action is: “Change a servo drive unit.”
Braking time is too long due to prolonged excessive input power voltage or excessively large braking resistance causing DC bus voltage rise. The manual's first action is: “Apply a power which meets the working needs o…
Motor's heat overload occurs when rated current parameter setting is wrong or the motor runs for long time with excessive rated current. The manual's first action is: “Set correctly the drive unit's parameter accordin…
Overcurrent alarm triggers due to prolonged operation with excessive rated torque, bad grounding, or damaged motor insulation. The manual's first action is: “Reduce the load or change a motor with a bigger motor.”
Servo unit internal IPM module failure occurs when power-on without enabling drive unit, short circuit exists between motor lines or braking resistor terminal, or the drive unit is faulty. The manual's first action is…
Motor encoder signal feedback is abnormal due to poor or wrong wiring, excessive cable length causing voltage drop, or damaged encoder. The manual's first action is: “Check the connector and signal wire welding condit…
Position deviation counter overflow occurs when electronic gear ratio is set too large or input command pulse is abnormal after Err-4 alarm is shielded. The manual's first action is: “Check the setting of PA29, PA30.”
Drive prohibition is abnormal because the FSTP/RSTP drive prohibition input terminal is OFF, and this alarm can be shielded if PA138=0. The manual's first action is: “A. Check the connection and 24V power supply of 24…
Speed amplifier saturation failure occurs when U,V,W phases are reversed, motor parameters are incorrect, or torque limitation is too small and rigidity is insufficient. The manual's first action is: “Connect correctl…
Motor's excessive temperature triggers alarm due to prolonged heavy load, frequent start/stop cycles, or damaged motor temperature sensor or fan. The manual's first action is: “Reduce the load or increase the power of…
Position deviation counter exceeds the setting value because pulse command frequency is too high, electronic gear ratio is too large, load inertia is excessive, or motor encoder is faulty. The manual's first action is…
Main circuit DC bus voltage is too low due to insufficient input power capacity or a faulty servo unit control panel. The manual's first action is: “Check the power capacity and electrical control cabinet.”
Main circuit DC bus voltage is excessive because the braking resistor is disconnected, damaged, or has an excessive resistance value. The manual's first action is: “Check braking resistor and its connection.”