NIDEK Le 1000 Error 0204: The front surface cannot be measured after rear surface measurement.

Patternless edger · taken from the manufacturer’s manual, pages cited

Error code0204

Front surface cannot be measured after rear surface has been measured. The manual's first action is: “Lightly press the feelers during front surface measurement.”

Model
NIDEK Le 1000
Display shows
0204
Type
Error code
Source
Manual p. 150

What 0204 means

The front surface cannot be measured after rear surface measurement. p. 150

Common causes

  • The front surface cannot be measured after rear surface measurement. p. 150

What to do

  1. Lightly press the feelers during front surface measurement. p. 150

Before you service the product, read the safety instructions in the manual p. 3.

If 0204 is still not resolved

  • contact NIDEK or your authorized distributor p. 3
    “If you encounter any problems or have questions about the instrument, please contact NIDEK or your authorized distributor.”
  • contact NIDEK or your authorized distributor p. 3
    “In this manual, signal words are used to designate the degree or level of safety alerting. The definitions are as follows. WARNING • Indicates a potentially hazardous situation whic h, if not avoided, mi ght result in death or serious injury.”
Open the manual at page 150 All Le 1000 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 0204; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with NIDEK. Found a mistake? Report an error.