NIDEK Le 1000 Error 0108: The wheel does not rotate at start of processing.

Patternless edger · taken from the manufacturer’s manual, pages cited

Error code0108

Wheel fails to rotate at the start of processing. The manual's first action is: “Turn off the power and then turn it on again after 20 seconds or more.”

Model
NIDEK Le 1000
Display shows
The wheel does not rotate at start of processing. (0108)
Type
Error code
Source
Manual p. 150

What 0108 means

The wheel does not rotate at start of processing. p. 150

Common causes

  • The wheel does not rotate at start of processing. p. 150

What to do

  1. Turn off the power and then turn it on again after 20 seconds or more. p. 150

Before you service the product, read the safety instructions in the manual p. 3.

If 0108 is still not resolved

  • contact NIDEK or your authorized distributor p. 3
    “If you encounter any problems or have questions about the instrument, please contact NIDEK or your authorized distributor.”
  • contact NIDEK or your authorized distributor p. 3
    “In this manual, signal words are used to designate the degree or level of safety alerting. The definitions are as follows. WARNING • Indicates a potentially hazardous situation whic h, if not avoided, mi ght result in death or serious injury.”
Open the manual at page 150 All Le 1000 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 0108; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with NIDEK. Found a mistake? Report an error.