Mitsubishi Electric 600M Series Error SYW0006: PLC signal

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codeSYW0006

An emergency stop signal was input from the PLC. The manual's first action is: “Cancel the signal with a machine switch such as READY.”

Model
Mitsubishi Electric 600M Series
Display shows
PLC signal (SYW0006)
Type
Error code
Source
Manual p. 496

What SYW0006 means

PLC signal p. 496

Common causes

  • An emergency stop signal was input from the PLC. p. 496

What to do

  1. Cancel the signal with a machine switch such as READY. p. 496

Before you service the product, read the safety instructions in the manual p. 4.

If SYW0006 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 496 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about SYW0006; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.