Mitsubishi Electric 600M Series Error PRW0001: Overlap address exists

CNC milling machine · taken from the manufacturer’s manual, pages cited

Warning codePRW0001

Too many addresses were specified in a single program block, causing previous address commands to be ignored. The manual's first action is: “Reconsider the program.”

Model
Mitsubishi Electric 600M Series
Display shows
Overlap address exists (PRW0001)
Type
Warning code
Source
Manual p. 505

What PRW0001 means

Overlap address exists p. 505

Common causes

  • Because the No. of addresses that can be simultaneously commanded in one block was exceeded, the previously designated address was ignored. p. 505
  • No. of addresses that can be simultaneously commanded in one block : M = Max. 4 addresses. Other than M = 1 address p. 505

What to do

  1. Reconsider the program. p. 505

Before you service the product, read the safety instructions in the manual p. 4.

If PRW0001 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 505 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about PRW0001; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.