Mitsubishi Electric 600M Series Error PR0452: Movement limit

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codePR0452

Movement limit occurs when an axis movement starts or ends within a prohibited area designated by the pre-movement stroke check function. The manual's first action is: “Reconsider the axis address coordinate value in the program.”

Model
Mitsubishi Electric 600M Series
Display shows
Movement limit (PR0452)
Type
Error code
Source
Manual p. 487

What PR0452 means

Movement limit p. 487

Common causes

  • When the axis movement start point or end point is in the prohibited area designated with the pre-movement stroke check function, an alarm will occur before executing that movement block. p. 487

What to do

  1. Reconsider the axis address coordinate value in the program. p. 487

Before you service the product, read the safety instructions in the manual p. 4.

If PR0452 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 487 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about PR0452; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.