Mitsubishi Electric 600M Series Error PR0435: G27 and M commands in same block

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codePR0435

G27 and M commands in same block means a G27 command cannot be used with any individual M command within the same program block. The manual's first action is: “An M individual command cannot be issued in a G27 command block and so the G27 command and M individual command must be placed in separate blocks.”

Model
Mitsubishi Electric 600M Series
Display shows
G27 and M commands in same block (PR0435)
Type
Error code
Source
Manual p. 486

What PR0435 means

G27 and M commands in same block p. 486

Common causes

  • An M individual command was issued simultaneously in the G27 command block. p. 486

What to do

  1. An M individual command cannot be issued in a G27 command block and so the G27 command and M individual command must be placed in separate blocks. p. 486

Before you service the product, read the safety instructions in the manual p. 4.

If PR0435 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 486 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about PR0435; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.