Mitsubishi Electric 600M Series Error PR0036: Program end error

CNC milling machine · taken from the manufacturer’s manual, pages cited

Error codePR0036

"EOR" has been read during tape and memory operation. M02 and M30 are not entered at the end of the program. M99 is not entered at the end of the subprogram. (Or, G23 or G68 is not entered at the end. The manual's first action is: “Reconsider the program.”

Model
Mitsubishi Electric 600M Series
Display shows
Program end error (PR0036)
Type
Error code
Source
Manual p. 477

What PR0036 means

Program end error p. 477

Common causes

  • "EOR" has been read during tape and memory operation. M02 and M30 are not entered at the end of the program. M99 is not entered at the end of the subprogram. (Or, G23 or G68 is not entered at the end of the subprogram when it is compliant with an M2/M0 format.) p. 477

What to do

  1. Reconsider the program. p. 477

Before you service the product, read the safety instructions in the manual p. 4.

If PR0036 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 477 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about PR0036; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.