Mitsubishi Electric 600M Series Error OPW0125: In axis control

CNC milling machine · taken from the manufacturer’s manual, pages cited

Alarm codeOPW0125

Starting is not possible because an axis is already being controlled. The manual's first action is: “Restart after stopping the axis being controlled.”

Model
Mitsubishi Electric 600M Series
Display shows
In axis control (OPW0125)
Type
Alarm code
Source
Manual p. 502

What OPW0125 means

In axis control p. 502

Common causes

  • Starting was not possible because the axis is already being controlled. p. 502

What to do

  1. Restart after stopping the axis being controlled. p. 502

Before you service the product, read the safety instructions in the manual p. 4.

If OPW0125 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 502 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about OPW0125; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.