Mitsubishi Electric 600M Series Error OPW0124: In synchronous correction mode

CNC milling machine · taken from the manufacturer’s manual, pages cited

Alarm codeOPW0124

The synchronous correction mode switch was turned ON in a non-handle mode. The manual's first action is: “Select the handle mode.”

Model
Mitsubishi Electric 600M Series
Display shows
In synchronous correction mode (OPW0124)
Type
Alarm code
Source
Manual p. 502

What OPW0124 means

In synchronous correction mode p. 502

Common causes

  • The synchronous correction mode switch was turned ON in a mode other than the handle mode. p. 502

What to do

  1. Select the handle mode. p. 502
  2. Turn OFF the synchronous correction mode switch. p. 502

Before you service the product, read the safety instructions in the manual p. 4.

If OPW0124 is still not resolved

  • contact service / dealer p. 5
    “Do not change the fixed cycle program without prior consent from the machine manufacturer.”
  • contact service / dealer p. 5
    “Do not turn OFF the NC a”
Open the manual at page 502 All 600M Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about OPW0124; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Mitsubishi Electric. Found a mistake? Report an error.