(Warning only) A timing parameter was out of range and has been adjusted. The manual's first action is: “For example, sending an RT command with a delay of 0 will get a reply of “Err 5”. When settings are viewed delay will have been set to 20us.”
- Model
- JM Vistec DLC-C2P6-D-E
- Display shows
- Err 5
- Type
- Error code
- Source
- Manual p. 13
What Err 5 means
(Warning only) A timing parameter was out of range and has been adjusted. p. 18
Common causes
- (Warning only) A timing parameter was out of range and has been adjusted. p. 18
- One of parameters is out of range. The value of the parameter has been adjusted. p. 18
What to do
- For example, sending an RT command with a delay of 0 will get a reply of “Err 5”. When settings are viewed delay will have been set to 20us. p. 18
Before you service the product, read the safety instructions in the manual p. 3.
If Err 5 is still not resolved
This page summarises what the manufacturer’s manual says about Err 5; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with JM Vistec. Found a mistake? Report an error.
